Toilet Repair in Raleigh

Usually a faulty flapper, fill valve, or flush valve. These are inexpensive repairs that stop water waste and save money on your water bill.

A running toilet can waste 200+ gallons per day, adding $50-100+ to your monthly water bill. Fixing it quickly pays for itself.

Toilets made before 1994 use 3.5-7 gallons per flush. Modern toilets use 1.28 or less. If repairs exceed $150-200, replacement often makes more sense.

Yes. Toto is one of the most common premium toilet brands in Raleigh's luxury communities. We are familiar with Toto's fill valve, flush valve, and dual-flush systems and can source the correct manufacturer components for repairs. We also service other high-end brands including Kohler, Grohe, and Duravit.

Yes. If your HOA specifies a particular model, finish, or brand for replacement toilets, we can work within those requirements. We recommend confirming the exact specification with your HOA before we order or install a new fixture so everything is compliant from the start.

Dual-flush toilets have two flush options — typically a half flush for liquid waste and a full flush for solid waste. They use a different internal mechanism than standard single-flush toilets, with a tower flush valve rather than a traditional flapper system. Repairs require familiarity with the specific dual-flush mechanism, which varies by brand. We are experienced with these systems.

If replacing the flapper did not stop the running, the fill valve is likely the culprit — either it is not shutting off properly when the tank reaches the set level, or the float is adjusted incorrectly and the tank overfills into the overflow tube. In some cases the flush valve seat itself is worn and no flapper seals against it properly. We diagnose the full system rather than just replacing one part at a time.

Yes. Toto flush valve assemblies and flappers are available through HVAC suppliers and we keep the most common Toto repair components on hand. Toto uses a proprietary flush valve design — the Toto flapper is a specific part that should not be substituted with a generic replacement if you want a reliable, lasting repair.

A newly installed toilet that runs is usually caused by one of three things: the fill valve float is set too high and water is running into the overflow tube, the flapper was not seated correctly during installation, or the supply line connection at the fill valve is slightly loose. We can diagnose and correct any of these quickly — a new toilet should not run from day one.